泡沫消火栓安裝的8個要素
來源：http://www.xintli.net/ 日期：2023-03-15
1.泡沫液儲罐周圍要留有足夠檢修需要的通道，寬度不能小于0.7m，操作面不能小于1.5m；當泡沫液儲罐上的控制閥距地面高度大于1.8m時，需要在操作面處設置操作平臺或操作凳。
1. There should be enough access around the foam concentrate storage tank for maintenance. The width should not be less than 0.7m, and the operating surface should not be less than 1.5m; When the control valve on the foam concentrate tank is more than 1.8m above the ground, it is necessary to set up an operating platform or bench at the operating surface.
2.泡沫液管道的出液口不能髙于泡沫液儲罐較低液面的1m，泡沫液管道的吸液口距離泡沫液儲罐底面不小于0.15m，而且較好能做成喇叭口形狀。
2. The liquid outlet of foam concentrate pipeline shall not be 1m higher than the lower liquid level of foam concentrate tank. The distance between the liquid suction port of foam concentrate pipeline and the bottom of foam concentrate tank shall not be less than 0.15m, and it is better to be made into a bell mouth shape.
3.常壓鋼質泡沫液儲罐內、外表面需要進行防腐處理，防腐處理要在嚴密性試驗合格后進行。
3. The internal and external surfaces of atmospheric steel foam liquid storage tank need to be treated with anti-corrosion treatment after the tightness test is qualified.
4.常壓泡沫液儲罐的安裝方式要符合設計要求，當設計沒有要求時，要根據形狀按立式或臥式安裝在支架或支座上，支架要與基礎固定，安裝時不能損壞儲罐上的配管和附件。
4. The installation method of atmospheric foam concentrate storage tank shall meet the design requirements. If there is no design requirement, it shall be installed on the support or support vertically or horizontally according to the shape. The support shall be fixed to the foundation, and the piping and accessories on the storage tank shall not be damaged during installation.
5.常壓泡沫液儲罐罐體與支座接觸部位的防腐要符合設計要求，當設計沒有要求時，要按加強防腐層的做法施工。
5. The anti-corrosion of the contact part between the normal pressure foam concentrate tank body and the support shall meet the design requirements. If there is no design requirement, the construction shall be carried out according to the method of strengthening the anti-corrosion coating.
6.泡沫液儲罐上設有槽鋼或角鋼焊接的固定支架，安裝時，用地腳螺栓將支架與地面上澆筑混凝土的基礎牢固固定，這個裝置較好安裝在室內；泡沫液儲罐是制造廠家的定型設備，上邊設有閥、進料孔、排氣孔、排渣孔、人孔和取樣孔等附件，在安裝時不能隨意拆卸或損壞。
6. The foam concentrate storage tank is equipped with a fixed support welded with channel steel or angle steel. During installation, the support is firmly fixed with the foundation poured with concrete on the ground with anchor bolts. This device is better installed indoors; The foam concentrate storage tank is the finalized equipment of the manufacturer. It is equipped with safety valves, feed holes, exhaust holes, slag discharge holes, manholes, sampling holes and other accessories, which cannot be dismantled or damaged at will during installation.
7.
川消小編認為，其放水管長度要根據已有的建筑設施、下道位置等現場自定。而且，安裝完畢后，應進行一次系統密封性試驗，貯液罐和管道不允許有滲漏現象，閥不能失靈。
7. Sichuan Xiaobian believes that the length of the drain pipe should be determined according to the existing building facilities and the location of the next channel. Moreover, after installation, a system sealing test shall be carried out. The liquid storage tank and pipeline shall not have leakage, and the safety valve shall not fail.
8.對于設置在露天地方的泡沫液儲罐，需要采取防曬、防凍和防腐等措施。當環境溫度低于0℃時，需要采取防凍設施；當環境溫度高于40℃時，需要有降溫措施；當安裝在有腐蝕性的地區，如海邊、湖邊等地方，則需要采取防腐措施。
8. For the foam liquid storage tank set in the open air, sunscreen, antifreeze, anti-corrosion and other measures need to be taken. When the ambient temperature is lower than 0 ℃, anti-freezing facilities shall be taken; When the ambient temperature is higher than 40 ℃, cooling measures shall be taken; When it is installed in corrosive areas, such as seaside, lakeside and other places, anti-corrosion measures need to be taken.
此外泡沫消火栓常常安裝在室外的漏天場所，并且常年遭受風吹日曬，外觀的涂漆時日長了便會遭剝蝕、脫落、導致外表生銹，因此要定期檢修，以延長使用壽命。更多相關消防設備事項就來咨詢我們
http://www.xintli.net吧！
In addition, foam fire hydrants are often installed in the open air, and are exposed to the wind and sun all the year round. The appearance of the fire hydrants will be corroded, peeled off and rusted after a long time of painting. Therefore, regular maintenance is required to extend the service life. Please contact us for more information about fire-fighting equipment http://www.xintli.net Come on!
