報警閥組的驗收應符合怎樣的要求？
來源：http://www.xintli.net/ 日期：2023-01-02
報警閥組是自動噴水滅火系統的關鍵組件，驗收中常見的問題是控制閥安裝位置不符合設計要求，不便操作，那么報警閥組的驗收應符合怎樣的要求？
川消小編為您解答！
The alarm valve group is a key component of the automatic sprinkler system. The common problem in the acceptance is that the installation position of the control valve does not meet the design requirements and it is inconvenient to operate. What requirements should the acceptance of the alarm valve group meet? Sichuan Xiaobian answers for you!
一、報警閥組的各組件應符合產品標準要求。
1、 All components of alarm valve group shall meet the requirements of product standards.
二、打開系統流量壓力檢測裝置放水閥，測試的流量、壓力應符合設計要求。
2、 Open the drain valve of the system flow and pressure detection device, and the flow and pressure tested shall meet the design requirements.
三、水力警鈴的設置位置應正確。測試時，水力警鈴噴嘴處壓力不應小于0.05MPa，且距水力警鈴3m遠處警鈴聲聲強不應小于70dB。
3、 The setting position of the hydraulic alarm bell shall be correct. During the test, the pressure at the nozzle of the hydraulic alarm bell shall not be less than 0.05MPa, and the sound intensity of the alarm bell 3m away from the hydraulic alarm bell shall not be less than 70dB.
四、打開手動試水閥或電磁閥時，雨淋閥組動作應可靠。
4、 When opening the manual water test valve or solenoid valve, the deluge valve group shall operate reliably.
五、控制閥均應鎖定在常開位置。
5、 Control valves shall be locked in the normally open position.
六、空氣壓縮機或水災自動報警系統的聯動控制，應符合設計要求。
6、 The linkage control of air compressor or automatic flood alarm system shall meet the design requirements.
七、打開末端試（放）水裝置，當流量達到報警閥動作流量時，濕式報警閥和壓力開關應及時動作，帶延遲器的報警閥應在90s內壓力開關動作，不帶延遲器的報警閥應在15s內壓力開關動作。雨淋報警閥動作后15s內壓力開關動作。
7、 Open the end water test (drainage) device. When the flow reaches the action flow of the alarm valve, the wet alarm valve and pressure switch shall act in time. The alarm valve with the delayer shall act as the pressure switch within 90s, and the alarm valve without the delayer shall act as the pressure switch within 15s. The pressure switch acts within 15s after the deluge alarm valve acts.
此外對于使用閘閥又無鎖定裝置，有些閘閥處于半關閉狀態，這是很危險的。所以要求使用閘閥時需有鎖定裝置，否則應使用信號閥代替閘閥。更多相關內容就來我們網站
http://www.xintli.net進行咨詢！
In addition, there is no locking device for gate valves, and some gate valves are in semi closed state, which is very dangerous. Therefore, it is required to have a locking device when using the gate valve, otherwise the signal valve should be used instead of the gate valve. More relevant content will come to our website http://www.xintli.net Consult!
