川消消防泵防止銹蝕現象的措施
來源：http://www.xintli.net/ 日期：2022-09-08
消防泵的使用關乎到用戶的生命財產，消防泵的供水性能穩定對用戶來說很重要，長期使用難免出現銹蝕、磨損的問題，如何防止消防泵銹蝕、磨損？
川消小編為您解答。
The use of the fire pump is related to the safety of users' lives and property. The stable water supply performance of the fire pump is very important to users. Corrosion and wear are inevitable in long-term use. How to prevent corrosion and wear of the fire pump? Chuanxiao Xiaobian will answer for you.
人工除銹是一種比較死板的除銹方法，費時費力。但誰都可以操作。也是非常省錢的一種方法。敲銹錘拷去厚的銹蝕物，用刮刀鏟去薄的銹層。
Manual derusting is a relatively rigid derusting method, which is time-consuming and laborious. But anyone can operate it. It is also a very economical way. Knock the rust hammer to remove the thick rust, and use a scraper to remove the thin rust.
手工除銹方法簡便，但勞動強度大，除銹效率和質量低下，一般只能除去疏松的鐵銹和失效舊涂層，所以目前僅用于機械類除銹，好比消防泵。這種除銹方式，達不到的各個方面的除銹，消防泵除銹后也不會顯得特別新，只能在主要部位，清理明顯的鐵銹。
Manual derusting method is simple, but it is labor-intensive, with low derusting efficiency and quality. Generally, it can only remove loose rust and invalid old coatings. Therefore, it is only used for mechanical derusting, such as fire pumps. This method of derusting can not achieve the derusting in all aspects, and the fire pump will not look particularly new after derusting. Only the obvious rust can be cleaned in the main parts.
要購買合格的消防泵，消防泵的性能和質量要符合的消防泵標準，嚴格按照標準執行生產的消防泵材質是合格的。消防泵在安裝之后需要運行4小時左右觀察是否有問題，之后才能投入持續使用。
Qualified fire pumps shall be purchased. The performance and quality of fire pumps shall meet the national fire pump standards. The materials of fire pumps produced in strict accordance with the national standards shall be qualified. After the fire pump is installed, it needs to run for about 4 hours to observe whether there is any problem before it can be put into continuous use.
由于消防泵不是一直運行的，零部件在水中閑置容易生銹，要定期啟動運行一段時間，防止內部生銹問題，定期檢查葉輪、軸承、密封環、水泵外表面是否有磨損銹蝕的情況，及時更換、修補，如果長期停用消防泵應該將各部件涂上黃油保存。
Since the fire pump does not run all the time, spare parts are easy to rust when they are idle in the water. It is necessary to start the pump regularly for a period of time to prevent internal rust. It is necessary to regularly check whether the impeller, bearing, seal ring and outer surface of the pump are worn and rusted, and replace and repair them in time. If the fire pump is stopped for a long time, all components should be coated with grease for storage.
消防泵的外殼涂有一層油漆，可有效防止外殼生銹。在使用中，盡量避免碰撞，使消防泵的涂料脫落，萬一涂料脫落，要及時修理。
The shell of the fire pump is coated with a layer of paint, which can effectively prevent the shell from rusting. In use, collision shall be avoided as far as possible to make the paint of the fire pump fall off. If the paint falls off, it shall be repaired in time.
消防泵緊急情況使用，不管是電動消防泵還是柴油機消防泵都應該定期維護檢查，在氣溫較低的時候還要做好保暖措施，這些都是為了使消防泵的能穩定運行、延長使用壽命。
When the fire pump is used in an emergency, whether it is an electric fire pump or a diesel fire pump, it should be regularly maintained and checked, and thermal measures should be taken when the temperature is low. All these are to ensure the stable operation of the fire pump and extend its service life.
為了減少各種故障出現，“防比治更加有效”！如果有問題應該及時聯系廠家或者售后，切勿盲目排除故障。
In order to reduce the occurrence of various faults, "prevention is more effective than cure"! If there is any problem, contact the manufacturer or after-sales service in time. Do not blindly remove the fault.
作為生產川消消防泵廠家，川消多年經驗總結提醒廣大用戶要防止消防泵生銹，川消消防泵按照規定有選材和性能、質量要求，的制泵廠家生產的水泵產品質量較為可靠些，您有需求就來我們網站
http://www.xintli.net咨詢看看吧。
As a professional manufacturer of Chuanxiao fire pumps, Chuanxiao's experience for many years reminds users to prevent fire pumps from rusting. Chuanxiao fire pumps have material selection, performance and quality requirements according to national regulations. The quality of water pumps produced by professional pump manufacturers is more reliable. Please come to our website if you need http://www.xintli.net Let's consult.
