川消消防泡沫炮三種故障問題分析
來源：http://www.xintli.net/ 日期：2022-05-30
消防泡沫炮能很好地防止火災，廣泛用于各種公共場所和高大空間。然而，一切都有失敗的可能，消防泡沫炮也不例外。為此，小編就為大家總結一下消防泡沫炮存在的問題及故障分析。
Fire foam monitor can prevent fire well and is widely used in various public places and large spaces. However, everything has the possibility of failure, and the fire foam monitor is no exception. To this end, I will summarize the problems and fault analysis of fire foam monitor for you.
消防泡沫炮故障問題分析：
Fault analysis of fire foam monitor:
消防中心無法遠程啟停消防炮
The fire control center cannot start or stop the fire monitor remotely
當消防中心無法遠程啟動或停止消防炮時，檢查電路是否開路或斷路，并檢查和維護電路，看看在原線路釋放時是否有備用電路；二是非標聯動柜按鈕開關連接不良或多線控制板松動損壞。多線控制板損壞，檢查維修設備。
When the fire control center cannot start or stop the fire monitor remotely, first check whether the circuit is open or open, and check and maintain the circuit to see if there is a backup circuit when the original circuit is released; Second, the button switch of non-standard linkage cabinet was poorly connected or the multi wire control board was loose and damaged. The multi line control board is damaged. Check and repair the equipment.
消防炮啟動后管網無法加壓
The pipe network cannot be pressurized after the fire monitor is started
一般來說，除了消防炮本身之外，還有兩種常見的故障。管網中空氣過多。管網抽空，再對消防炮加壓。二是消防炮在地上，水池在地下，消防炮在地上。與水池相連的管網下方有一個吸水底閥。由于吸入底閥不能停水，管網內充滿空氣，消防炮啟動后不能打開吸入底閥，吸不到水。向上壓并檢修吸入底閥。
Generally speaking, in addition to the fire monitor itself, there are two common faults. There is too much air in the pipe network. The pipe network is evacuated and the fire monitor is pressurized. Second, the fire monitor is on the ground, the pool is underground, and the fire monitor is on the ground. There is a suction bottom valve under the pipe network connected with the pool. Since the suction bottom valve cannot stop water supply and the pipe network is full of air, the suction bottom valve cannot be opened after the fire monitor is started, and water cannot be sucked. Press upward and repair the suction bottom valve.
消防泡沫炮的出水口既不是柱狀也不是霧狀
The water outlet of fire foam monitor is neither columnar nor foggy
安裝水炮前，需要在與消防管網連接的電磁閥前安裝過濾器，消防管網必須對軟管加壓，將管內的污物或焊渣吹出。防止管道內容物在高壓沖擊下?lián)p壞閥門。其次，會影響水炮的出水量。如果整流器中有東西堵塞，水炮輸出的水既不是柱狀也不是霧狀的。這個時候，如果要處理，
川消人員建議需要廠家的人員了。
Before installing the water monitor, it is necessary to install a filter in front of the solenoid valve connected to the fire pipe network. The fire pipe network must pressurize the hose to blow out the dirt or welding slag in the pipe. Prevent pipeline contents from damaging the valve under high pressure impact. Secondly, it will affect the water output of the water cannon. If something in the rectifier is blocked, the water output from the water cannon is neither columnar nor foggy. At this time, if it needs to be handled, the Sichuan consumer suggested that the manufacturer's professionals be needed.
希望以上介紹對你有幫助。需要再次強調的是，當消防泡沫炮發生故障時，不要著急，只要遵循合理的方法，通過檢查方法很容易問題。更多內容就來網站
www.xintli.net咨詢了解吧！
I hope the above introduction is helpful to you. It should be emphasized again that when the fire foam monitor breaks down, do not worry. As long as you follow reasonable methods, it is easy to solve the problem through inspection methods. For more information, please visit www.cx-fire Www. 68mn!
